180-701_ALT_4.jpg
180-701_ALT_4.jpg
 
180-701_ALT_0
 
180-701_ALT_1
 
180-701_ALT_2
 
180-701_ALT_3
 
180-701_ALT_4
 

Wired Home DBIRX Infrared Repeater System Kit Dual Band

Brand:| Model: DBIRX
Overview
This IR repeater kit from Wired Home has everything needed to get started with a distributed infrared system. Get that A/V equipment out of sight without sacrificing control!
Highlights
  • Transmits both 38 kHz and 56 kHz IR bands
  • Control AV components located behind closed doors
  • Easy setup, no tools needed
  • Includes 2 dual-output emitters
  • Emitters snap into a unique saddle for easy removal
Part # 
180-701
Weight: 0.75 lbs.  
IN STOCK
List Price$51.99
You Save43%
Your Price
$29.50
Buy 4-up$28.00
Part # 180-701
Qty:  EA
Available Payment Methods

Product Details

Wired Home DBIRX Infrared Repeater System Kit Dual Band

With a Wired Home IR Repeater system, you can locate your A/V components out of sight in a closet or cabinet and still use your remote control.

The central module features industry-standard jacks for power, target, and emitters, so no tools are needed for installation. Screw tabs on the sides of the control module allow it to be permanently attached to just about any surface. The system includes two double-emitters with two meter cords, to control up to four devices. The target has a one meter cord so it can be located away from the control module. There are two LEDs on the control module; the red LED shows the system has power and the green LED flashes to show signal transmission. A 5V DC power supply is included.



Wired Home DBIRX Infrared Repeater System Kit Dual Band
  • BrandWired Home
  • ModelDBIRX
  • Part Number180-701
  • UPC844632001437
  • Product CategoryIR Repeater Systems
  • Unit of MeasureEA
  • Product Rating
    (3 Reviews)
  • Weight0.75 lbs.
  • California Prop 65

    Warning: California residents only. Please note per Proposition 65 that this product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

Similar Products

View similar products to the Wired Home DBIRX Infrared Repeater System Kit Dual Band
in the IR Repeater Systems product category.

Reviews

Wired Home DBIRX Infrared Repeater System Kit Dual Band
Wired Home DBIRX Infrared Repeater System Kit Dual Band is rated 4.6667 out of 5 by 3.
Rated 4 out of 5 by from Great for adjacent cabinet/closetThe IR Repeater system is a bargain, and works great. I have done many where the TV was either close to a closet/cabinet or far away. This one is good for where the TV is adjacent to acloset or cabinet due to the factory length of the wires on the receiver and the emitters. The quarter size receiver is not the end of the world to me.
Date published: 2013-11-01
Rated 5 out of 5 by from DBIRX IR Repeater KitI have installed 3 of these and they perform flawlessly. I have used this repeater with brand-new equipment, old equipment, and most recently, a mix of mid-90s electronics and 2013 stuff...all work perfectly. I only wish the "eye" was smaller, then it would be easier to conceal, but for a stinkin' $29 it does all it is purported to do. Highly recommended.
Date published: 2013-06-17
Rated 5 out of 5 by from Works great with all devices connectedInitially the repeater seemd to only work occasionally...connection issue where the transmitter plug did not make good connection. Works fantastic! Highly recommended.
Date published: 2013-02-17

Product Q&A

Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email tech@parts-expresss.com  for a prompt reply.
Wired Home DBIRX Infrared Repeater System Kit Dual Band

How can I extend the range over Cat-5 or Coax?

I have both Cat-5 and coax run to from my wiring closet to where I would like the IR receivers to be. How can I extend using one of these cables?
Asked by: SBR140.6
A system like this can only use Cat 5 as a splice between the receiver (target) and hub. An easier solution would be to use a 3.5mm headphone extension cable at whatever length you need.
Answered by: MattP
Date published: 2013-02-05

How far does the emitter reach

How far can the emitter eye be from the hub to transmit. I have 33 ft between the emitter and the receiver.
Asked by: Ac man
The emitters used in this kit have a 10 foot cord. You can extend this up to around 100 feet using cat3 or cat 5 cable if needed.
Answered by: Chrisf
Date published: 2013-02-03

Very interested. Sounds cool. What exactly is it used for?

Asked by: Trogdor
This system is designed to allow you to put your A/V equipment in a cabinet or separate room and transmit the IR signal from the remote without needing to be line of sight with the devices. This system includes an IR target (which you point the remote at), a hub and four emitters which stick to the IR sensors on your electronics.
Answered by: MattP
Date published: 2012-11-08

Customer Projects

Customer projects that include: Wired Home DBIRX Infrared Repeater System Kit Dual Band

If you built a project using this product, post it in the Parts Express Project Gallery.

Customer Discussions


If you would like to start a discussion about this product, post a thread in the TechTalk Customer Forum.
Get Deals
emailed to you every week.

Be the first to hear about new and exciting products,special pricing and incredible deals!

See This Week's "GET DEALS" Email
Parts Express
725 Pleasant Valley Dr.Springboro,OH45066USA
800-338-0531

© 1996-2014 Parts Express, All Rights Reserved

Host-Name:ZNODE1