Speaker Cabinet Port Tube 1-7/8" ID x 5-5/8" L Flared
Speaker Cabinet Port Tube 1-7/8" ID x 5-5/8" L Flared is rated out of 5 by 9.
Rated 3 out of 5
by BLE Design
from Average PortI brought this port and installed it in my cabinet in a 2 5/8" cutout. Upon removing it from the cutout hole, the rib piece broke.Wasn't worth the expense of sending back. Just ordered another one and waiting for it to arrive. The other one I have works great.
Date published: 2014-11-17
Rated 4 out of 5
from Nice Flare Tube & Works WellAs scooby-11977 states, a 2 5/8" cutout with a jasper jig does the trick! Sand out the hole with 100 grit sandpaper abit and tap in the tube for a good snug fit! Test routed a 2 11/16" hole on a piece of scrap and it is too big for the tube and it just drops in...not good! A good product and does what it supposed to do
Date published: 2012-04-01
Rated 1 out of 5
from 5/16" taper in 5" length...Product not as described. This port tube has a flare on the large 2" I.D. end and tapers down to 1-11/16" on the other end, where it is square cut. Maybe I can adapt this to the carburetor on my lawnmower. It should be worth at least 10Hp.
Date published: 2011-07-31
Rated 5 out of 5
by P dizzle
from Good low-turbulence portGood low-turbulence port. This is a 50mm (2") inside diameter port. The port is slightly tapered along the length, so it will measure larger or smaller at either end, but it functions the same as a straight 2" ID port. Press-fits nicely in a 68mm cut-out and has a clean, professional look - no screws or thick flange sticking out.
Date published: 2011-05-27
Rated 1 out of 5
by Kent - 28916
from Product does not meet the specificationOther reviews is correct. This product does not meet the claimed specification and misleading.
Date published: 2010-02-24
Rated 2 out of 5
by Paul K - 17833
from I.D. is really a bit smaller.FWIWWith this product, outer diameter is 1 3/4", inner diameter is 1 5/8 ". So do your calculations as such. The mounting hole needs to be bigger still, due to the ribbed neck being bigger than the tube itself.
Date published: 2008-12-29