Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email firstname.lastname@example.org
for a prompt reply.
Selenium ST200 Super Tweeter
Can these tweeters be used on my Klipsch KG 4.2 speakers. They have Horns, and the tweeters need replacing. If these will not work, do you sell ones that will work?
These are not intended to mount to horn lenses. They are stand alone supertweeters. It is best to start by checking the way that the driver mounts to the horn lens
Date published: 2014-04-11
Crossover point on these is 5k.... what size cap should i use inline with it... and if i put it on a car amp... does it matter if the amp has full range on?
I usually recommend the high pass 2nd order in line filter for these drivers.http://www.parts-express.com/5-khz-high-pass-8-ohm-crossover--266-474The amp playing full range will not matter with that filter in place.
Date published: 2014-03-15
I keep blowing these tweeters..im only running them on high pass..but my question is do I need a in line crossover and if so which one do I need to start with?
Please email or call our tech support for further help with this problem, 800-338-0531 x1 or email@example.com.
Date published: 2014-02-24
Can this work well with a JBL crossover 2700 khz? I am matching two of these with a pair of midrange/bass for a 2 way system for home theater front speakers.
Unfortunately this is not recommended for a crossover lower than 5kHz.
Date published: 2013-12-04
What size capacitor should I use for a bass blocker?
For the lowest crossover frequency. I assume it would be around 4000 Hz for a first order crossover.
The recommended crossover for this tweeter is 5kHz so a first order would need to be about an octave above that to be safe. A 2.0 uF capacitor will work for this.
Date published: 2013-08-05
hello, planning on using these to replace blown tweets out of a jbl cf150 3 way. can i mount this in a horizontal manner, where the spkr terminals would be sideways? also, when i received my pair, one is showing me 5 ohms, and the other is at 6.4. seems like the one with lower rating also is a return, as the plastic packaging is not factory looking as the other one. tnx
The orientation of the terminals is not critical. How did you check the impedence? I am sure they would be the same.
Date published: 2013-03-15