1.  Thoroughly Clean the Surface Area
Clean each area to be treated with a residue free solvent such as isopropyl alcohol or acetone.

2.  Cut and Heat
Using a sharp utility knife or heavy duty scissors, cut the SDS to the desired shapes and sizes of the corresponding panel areas to be treated. Remove the blue liner that covers the adhesive backed side of the SDS that is to be affixed to the panels. When applying large SDS sheets, it is recommended to only remove about 8 to 10 inches of the blue liner at a time and slowly work your way down the panel. It is also recommend that you warm the adhesive side of the sheet and panel using a heat gun. This will ensure maximum adhesion to the surface area, and allow the sheet to better conform to the surface. For maximum effectiveness apply heat to the SDS after it has been applied to the panel area.

3.  Press and Roll
While still warm, use a roller tool to work the SDS into crevices and irregularities and to smooth surface. Starting from one end, work out all of the trapped air between the SDS and panel that you can.

Additional Installation Tips:

• Though 100% coverage is recommended for maximum noise reduction, 50% to 75% coverage will effectively damp vibration in most vehicles.
• When 100% coverage desired, it is best to butt SDS end to end, instead of overlapping the edges.
• For best results, apply SDS only when the ambient air temperature exceeds 70° F.

How much damping material do I need?
The amount of damping material needed for an application varies greatly with type of vehicle, area to be damped, and amount of damping desired. Calculate the surface area by blocking it off into squares and rectangles. Multiply the length of an area times the width (in inches), then divide by 144 to derive square feet. The rule of thumb is to add about 25% to your final area calculation to allow for trimming for irregularly-shaped areas and contours.

 Length in inches x Width in inches ÷ 144 = Area in square feet.