Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email firstname.lastname@example.org
for a prompt reply.
Pyle PDIWS10 10" In-Wall Subwoofer
Can I connect the speaker leads from a receiver to the sub?, then run leads from sub to the speakers? If so, please explain.
No, it is a dual voice coil speaker with two speaker inputs (one for each voice coil). It has no output for high level pas through to go to additional speakers.
Date published: 2015-05-21
Is there a recommended LP filter I can get with the sub?
There really is no such thing for this. The low pass filter will be determined by the end user, you will have to use whichever filter give you the best sound.
Date published: 2014-11-29
are these just installed in a closed 2x4 wall? Could I use a the amp off a old Sony SA-W2500 10" Powered Subwoofer
Yes these do not require a specific enclosure. As long as the amplifier is safe with a 4 ohm load, it will work fine with this woofer.
Date published: 2014-10-24
Pyle PDIWS10 10" In-Wall Subwoofer Do I need an external amp for this speaker
This is not a powered subwoofer so it does indeed require an amplifier for operation.
Date published: 2014-06-06
do you reccomend an amp to power these
A good amplifier for one of these would be our SA100. If you are going to have two, the SPA250 would be a better choice.
Date published: 2013-03-07