Dayton Audio WT3P WT3 Bundled with Precision Scale
Order a Dayton Audio WT3 Woofer Tester today and start testing your drivers using the most affordable speaker analysis test device available, and get a FREE precision scale! Dayton Audio's WT3 makes measuring loudspeaker parameters faster and more accurate than ever before. Previous generation woofer testers took around 6 minutes to measure 30 impedance points, while the new WT3 measures over 30,000 data points in a few seconds using an exclusive swept sine technique. The result is a high-resolution impedance measurement that allows for the extraction of extremely accurate driver parameters giving you the accurate measurements you need in a fraction of the time. Free air resonance may be measured in a few seconds. VAS can be measured by traditional test box, added mass or by specifying the 1W/1m SPL of the driver. No other loudspeaker impedance tester is as fast or as easy to use! WT3 hardware consists of a tiny USB interface device with cable and alligator leads. Windows-based software provides an easy-to-use interface that allows you to be testing very quickly. You can save as many as 20 impedance measurements per project and then overlay and compare measurements to create a custom report. Ideal for speaker QC.
The primary application for WT3 will be testing raw drivers in order to gather the speaker parameters required for speaker design, but loudspeaker designers can also use WT3 to verify the resonance and Q of completed loudspeaker systems. You can even measure the 1 kHz inductance of your crossover inductors and the impedance response of complete multi-way loudspeaker systems.
Minimum System Requirements:
- IBM PC or compatible system with 64MB RAM
- 500 MHz Pentium III processor
- MS Windows 98, Me, NT, 2000, XP, 7, or Vista
- One available USB 2.0/1.1 port
Take an Interactive Demo Tour of the WT3 Software (Requires Flash)
