Dayton PM105 Projector Mount with 5" Extension

I suppose you can't complain for the money, but what you are buying with this product is a box with about two dozen different types of screws, washers, little clips and so forth, with an almost indecipherable manual (it reads like it was automatically translated from another language). It can't be easy designing a product that fits every projector out there, but still.

The actual quality of the product is fine. Black screws would be nice (they would show up less against the other metal parts), but I don't expect miracles. There is a design flaw in the locking nut, which requires you to assemble everything, adjust the projector, then partially disassemble everything to tighten the locking nut.

The mount did not fit my projector perfectly, it was a bit of a fudge at best (I'm sure it will do, however). Again, huge partsexpress fan, not 100% satisfied with the design and manual.

Very easy to install and adjust, no major problems to finish installation in less than 20 minutes.

Decently solid mount as it comes from the factory. However, it wiggles a lot if you do not tighten the nut in the bottom of the ball joint. It's fine as long as you do this.