Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email firstname.lastname@example.org
for a prompt reply.
Parts Express Heavy Duty 12" Speaker Grill
I would REALLY love to have a grill cover like you sell.!!! Will this FIT the speaker on my Roland Cube 80X amp? The sooner I know...the sooner I will order. Also, where on here, do I buy the parts to put this on my speaker (12")?
This requires a bit more information in order to proceed. Please contact our tech support for more help with this question, email@example.com or 800-338-0531 x1.
Date published: 2015-06-25
Will this grill fit a Dayton RSS315-HFA-12"? (your part # 295-445) The outer mounting ring of the sub is flush with the cabinet, the driver protrudes beyond that.
I would not recommend using this type of grill with a large roll surround like what is used on the RSS series woofer. There is a chance that the surround could strike the grill on louder passages.
Date published: 2015-04-06
1. Can I drill clearance holes into the OD portion of the grille covered with the trim ring, to receive mounting screws? 2. What is the net height of the grille viewed from the side? Thank you.
The black ring around the grill is rubber so mounting it this way might be problematic. These are designed to be held in place with our grill clamp kits like below. The height of the grill is about 1/2".http://www.parts-express.com/penn-elcom-g0727kit-plastic-speaker-grill-clamp-kit--260-340
Date published: 2015-02-18
Will it fit a 12 inch Eminence "Screaming Eagle" guitar speaker?
Yes this will fit that speaker.
Date published: 2014-07-21
Need more detailed answer to my question
MattP I had a couple of specific questions. In particular whether the clamps would work with the speaker mounted internally and/or externally. Please see my original question
They will work regardless of the speaker being mounted internally or externally.
Date published: 2013-07-02
Will these work with a Dayton Audio PA310-8 12" woofer and 262-360 Clamp
I haven't decided yet whether to internally or externally mount the PA310-8. I would also like to use the Penn-Elcom G0727/NO Speaker Clamp (PE number 262-360). I don't see a spec on the thickness of the lip around this speaker grill. Will the clamps work with only the grill thickness if I internally mount the speaker? If I externally mount the speaker, the speaker spec says the height above the baffle will be 11 mm (0.433"). Adding the thickness of the speaker grill lip, will that be too high for the clamp? Is there space on the bottom side of the clamp to put a spacer if needed?
Yes this will work with the Dayton driver and those clamps.
Date published: 2013-07-02