Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email firstname.lastname@example.org
for a prompt reply.
Parts Express 80 Hz Low Pass 8 Ohm Crossover
I have drivers rated at 4 ohms impedance. Can this crossover be modified to function properly with this impedance rather than the 8 ohms design parameter?
In order for this to work at the same frequency with a 4 ohm load the component values will have to both be changed. You would be farther ahead buying the 4 ohm version of this filter which you can see below.http://www.parts-express.com/parts-express-80-hz-low-pass-4-ohm-crossover--266-440
Date published: 2014-11-04
ok,got the answer!.so I Am Looking For A 500 Watt Version of this Trying to do this right!!. can you tell me were I may find one?.
We do not have any higher powered low pass filters at this frequency available. We do have a couple at 250 Hz that handle about 600 watts, but those are the only options we have.
Date published: 2014-11-11
Have A 750 Watt 18"inch Sub can i use this with this sub ?. Have A Cabinet Maker friend of mine Building (186)Horns "Modified".I'm New to this but i'm willing to learn.what i want is to cut down on the hi side just a little.so is this crossover good.
This will work but you will be limited with the amount of input power you can feed it. This low pass filter is limited to 250 watts RMS, anything more than that and it will start to heat up and the components may fail.
Date published: 2014-11-03
I'd asked about using this inline to an *" subwoofer and Matt said not recommended and that I should replace the amplifier. I assume Matt was talking about a new plate amplifier? If so, there is a 50W and a 100W on your site that could work?
We have two models that will work well. The Dayton SA70 or SA100 will work fine for this application, as well as the Yung SD100.
Date published: 2014-03-18
I have an 8" active subwoofer whose amp and/or board has failed. Can I discard that package and wire this in between the speaker and the receiver subwoofer output?
I would not recommend connecting the woofer this way. It will provide a heavy load on that channel of the amplifier and will not sound the same nor have the same output if shared with the main speakers. I would recommend replacing the amplifier itself. We have many different models that can work for this.
Date published: 2014-03-17
i have two 4 ohms subs wired in series for 8 ohms load/bridge on my amp. i would just need one crossover, right? thanks
Yes you will only need one crossover.
Date published: 2014-02-26