Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email firstname.lastname@example.org
for a prompt reply.
Lepai LP-S60 4x25W Desktop Mini Amplifier with Remote USB MP3 Media Card FM
What is the wiring output on the 3.5mm?
Im planning to by the Bluetooth Module BT-1A and wanted to hard wire it to the 3.5mm output. I wanted to know the left, middle and right what they are. It is located bottom left corner on the blue pcb board.
The 3.5mm output of which unit?You are asking a question that would require reviewing the schematic carefully and perhaps making measurements. I would advise contacting PE Tech department for this info. However they may not be permitted to advise of any internal hobbyist modifications.
Date published: 2013-10-03
load of questions!
full power at 12V 5A, is there bass and trebble controls and output at 8 Ohms?
Yes this will provide full power at 12VC 5A, it does have bass and treble controls and will drive an 8 ohm load.
Date published: 2013-10-02
Do any owners of this unit have a way to test the RCA line out voltage?
I am considering getting one, or more, of these, but would like to know the RCA line out voltage before ordering to be sure it will work for my desired application...
Hey Jma.5 volts on my meter and this is the line out side RCA.avguy
Date published: 2013-04-08
what is the actual RMS rating of each speaker input? if I were to use an 12volt 8amp power supply, would I achieve 25 watts rms per channel or is the 'max 25watt' rating a peak power rating? if not, I'm assuming two 2020s will output more power. Thanks!
Assuming a 14 VDC supply the per channel output is 25 watts peak, with this rating RMS power out would be 17.7 watts. Decreasing the power supply to 12 VDC would drop rated output by an unknown amount.
Date published: 2013-03-20
What is the range of the remote?
I just bought one and hooked it up. The remote seems to only work within three feet of the unit. Is this typical, or should I try replacing the battery?
As long as the IR gets to the sensor eye it should work.
Date published: 2013-03-19
Do you have a pdf file of the manual in English?? Would be very helpful!
It would be nice if PE or Lepai would convert their Lepai amp manuals to .pdf and post them here. However, it's impossible to find Lepai's website...I dont think there is one. One of the main complaints about Lepai is the very limited instruction manual (it's just a spec sheet)...so good luck with that.
Date published: 2012-12-04