Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM

Brand:|Model: LP-269FS
All-in-one amplifiers simply don't get any better than this! The Lepai LP-269FS has enough features to replace most stereo receivers: FM tuner, MP3 playback with SD/MMC card and USB support, and an IR remote control. Power up to four speakers with the dual stereo output.
In Stock
List Price$89.99
Regular Price$39.00
You Save13%
Sale Price
Part # 310-304
  • All-in-one amplifier with SD/MMC card and USB input
  • Up to 4 x 45W of output
  • Power supply, IR remote, and FM antenna included
  • 2-ohm stable
  • Wide input range of 9 to 14.4 VDC for many applications

Product Details

Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM

Lepai's LP-269FS is an all-in-one mini amplifier that features an FM tuner, on-board MP3 decoder with SD/MMC and USB input, stereo RCA audio in with pass-through stereo RCA audio out, an IR remote control, as well as power output for four speakers. The built-in LCD display shows you the mode of operation as well as displaying time elapsed for MP3 files and the radio station tuning frequency.

Front mounted treble, bass, and volume controls, as well as a four function EQ (accessible via the remote control), allow you to dial in the sound to match your taste and get the most out of your speakers. A wide input voltage range of 9 to 14.4 VDC allows the LP-269FS to be used in automotive or mobile applications. Included with the amplifier are: an IR remote control, a 12 VDC, 2A power supply, and a 16" long FM antenna. Up to four speakers can be powered using the dual stereo output.

Specifications: • 4 x 45W max (output power is dependent upon power supply) • Power requirements: 9 to 14.4 VDC, 2A-5A • DC power input jack: 2.1 mm x 5.5 mm • Stable down to 2 ohms • Minimum THD: <1% • Signal-to-noise ratio: >80 dB • Frequency response: 20-20,000 Hz • Input impedance: 47k ohms • FM tuner frequencies: 87.5 to 108 MHz • FM receiver sensitivity: 16 dB • FM signal-to-noise ratio: 60 dB • Channel separation: 39 dB • Dimensions (including mounting flange): 7" W x 4-3/4" D x 1-3/4" H.

Product Specifications
  • Special FeaturesFM Tuner,USB Connectivity,SD Card Input,Remote Control
Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM
  • BrandLepai
  • ModelLP-269FS
  • Part Number310-304
  • UPC844632089374
  • Product CategoryHome Audio Amplifiers
  • Unit of MeasureEA
  • Product Rating
    (48 Reviews)
  • Weight2 lbs.
  • California Prop 65

    Warning: California residents only. Please note per Proposition 65 that this product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

View similar products to the Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM
in the Home Audio Amplifiers product category.


Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM
Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM is rated 3.7083 out of 5 by 48.
Rated 5 out of 5 by from Great mini amp for what I needThis is a great amp. I have 4 Dayton Exciter and 2 Pile tweeters connected to this with a 11.1 volt lipo ( lithium ion) battery and it cranks and sounds great. The battery last so far fro 8 hours. I don't know how the speaker were connected my son did all the work and he was the one who converted the power cord to connect with the battery and just sounds great like a car audio. The set up is for my velomobile which is perfect for the Dayton speakers because it uses the shell of the bicycle to amplify the music and it is loud and crystal clear.
Date published: 2015-10-06
Rated 2 out of 5 by from Not as good as described in the digital sectionThis is my third Lepai product purchase Lepai LP-269FS, the 2020A and the LP-168HA were the previous buys. Unfortunately this LP-269FS does come close to the other two. The FM reception is poor, the digital section is noisy with poor D to A conversion. The analog section is better but not as crisp as the 2020A. I will probably tinker with it, dismantle it and use some parts...The first PE product I do not recommend.
Date published: 2015-10-05
Rated 4 out of 5 by from Good unit for the priceThe unit does have background noise that increases with volume knob. It also was more noise when you use the SD card input. (Two sets of noise) There is only one set of noise if using the RCA inputs. Once music is playing it is able to overpower the noise. The noise is even with there with a 12v 5a power adapter with a line choke. I never even used the power adapter that came with the unit as many people said it had too much noise. I also DD.1'd the output of the amp. With the SD card input a 1khz 0dB tone is clean with the volume all the way up. A 40hz 0dB tone was clean up to 3/4 volume with the bass knob turned all the way up. Obviously if it was turned down the bass knob the volume was clean all the way up. There was an iffy spot about half way up in the volume where the dd.1 picked up some distortion with a 1khz tone. I don't have a scope so I'm not sure what that was about. The RCA input was also clean all the way up given that your source was not distorting. This unit did 8w on each of 2 channels with a 4 ohm speaker on each. (The SMD AMM.1 was used for that test) I imagine it would do more if a 2 ohm load were to be put on it. For my use it's plenty loud enough for my room. Now if you were on a back patio trying to make your neighbors mad, it probably wouldn't have enough power. I really can't complain about this unit for what I paid for it.
Date published: 2015-06-29
Rated 5 out of 5 by from Good Amp Great ValueI bought this amp a few months ago and paired some small NXT speakers from a Teac System that failed. I use this system to play podcasts and music at work and it sounds very good. There is a little noise when the amp is run at low volumes, but once you get over the noise floor it's fine. What do you want for $40.00? I think this amp is a great value and works just a described by Parts Express.I hooked up an old subwoofer I had laying around to the output section. Also, I noted in the Question and Answer section, a user mentioned holding the "previous channel - +" and changing the output of the unit, which is correct. The nice part about this is, if you use the output section of the amp for a powered subwoofer you can then use the "previous channel" control to adjust the gain of the subwoofer and use the volume pot to adjust the gain of your speaker outputs. This prevents me from stooping down to get the subwoofer which is on the floor and hidden.
Date published: 2015-04-06
Rated 2 out of 5 by from Meets my low expectationI had fairly low expectations for this amp based on the price. Needless to say, good thing I had low expectations.1) Hookup was a bit of a pain. I was using some standard 14 gauge wire and found it VERY difficult to get the wire into the push terminals. Even when I decided to use some wire pins it was very difficult to get the pins installed.2) I noticed was that while it is rated at 45 watts per channel it has a very difficult time pushing my outdoor speakers that I have in my garage. I have the volume turned all the way up and it is just loud enough for background music.3) As others have stated, there is a hum to this amp. It likely won't be a big issue since I am using this in the garage, but if I were using it anyplace else I'd be returning it tomorrow.4) A big disappointment, the FM tuner. JUNK! I can receive only one FM station. Even my cheap radio in my basement can pickup 4-5 of the local stations. I'll try to tweak it some more and hopefully I can get it to work better, but right now the only thing not chasing me to throw this thing away is that I paid $40 for it.
Date published: 2015-03-23
Rated 4 out of 5 by from Works Great!Bought this to just check out the function and run a pair of bookshelf speakers. Works as expected, it's replaced my Kenwood Receiver for FM and CD/DVD play.Only reason I took off a star is pronounced hum at about 85% + volume, but it's plenty loud with just slight noise up to 80%. Got a pair of the 652's on order to see how well it does with them.
Date published: 2015-03-17
  • 2015-12-01T06:39CST
  • bvseo_cps, prod_bvrr, vn_cps_3.1.6
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_48
  • loc_en_US, sid_310-304, PRD, sort_mostRecent
  • clientName_PartsExpressInternational

Product Q&A

Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email tech@parts-expresss.com  for a prompt reply.
Lepai LP-269FS 4x45W Mini Amplifier with Remote USB MP3 Media Card FM

Will this power anything through the USB  like MB-CM15112 bluetooth receiver

Asked by: Josephv82
Unfortunately the USB will only act as an input on this amplifier and not provide power for devices.
Answered by: MattP
Date published: 2015-11-30

Will this unit work effectively through/into a 50 watt PA speaker??  Thanks a lot.

Asked by: Jim1964
This will drive a PA speaker without issue as long as the impedance rating on the speaker is 4 ohms or higher. Whether it has enough output for your application can only be determined by trying it unfortunately.
Answered by: MattP
Date published: 2015-09-14

Do you hae replacement remotesfor Lepai?

Asked by: Abear
Unfortunately we do not have replacement remotes available for these amplifiers.
Answered by: MattP
Date published: 2015-05-27

I just purchased a model lp-269 and the volume buttons on the remote control unit do not work. I tried taping repeatably and holding them down, but the volume does not change. The on/off, mode, and mute buttons all work okay.

Asked by: johnny27
Please contact our tech support for more help with this question, tech@parts-express.com or 800-338-0531 x1.
Answered by: MattP
Date published: 2015-04-27

I can't get my iPod to play on this amp using the USB input. The iPod "connects" like it's hooked to a PC. Should it work this way or do I have to put MP3's on a thumb drive to use the USB input?

Asked by: Playa Putter
The USB is a "play" function only and is used for a thumb drive type input. You can use a 3.5mm to RCA cable for use with your iPod.
Answered by: TomI
Date published: 2015-04-12

can I add a sub to this amp?

Asked by: ted1950
You could if you use a low pass filter.
Answered by: TomI
Date published: 2015-04-06
  • 2015-12-01T07:16CST
  • bvseo_cps, prod_bvqa, vn_cps_3.1.6
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_73
  • loc_en_US, sid_310-304, PRD, sort_recentQuestionsFirst
  • clientName_PartsExpressInternational
Get Deals
emailed to you every week.

Be the first to hear about new and exciting products,special pricing and incredible deals!

See This Week's "GET DEALS" Email
Get Sales Flyer
Parts Express
725 Pleasant Valley Dr.Springboro,OH 45066USA

© 1986-2015 Parts Express, All Rights Reserved

Live Chat Software