Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email email@example.com
for a prompt reply.
Dayton Audio BPP-G Premium Binding Post Pair Gold
Spades on the amplifier cable?
Can I use amplifier-to-speaker cables terminated in spade lugs to connect to these binding posts? If yes, what inner opening diameter is needed for the spade lugs?
Yes spades can be used with these. The ID would need to be 5/16".
Date published: 2013-11-07
What is the largest awg wire the holes in the binding post can hold ?
The holes will only accept about 18 AWG wire, although using female disconnects or soldering directly to the tab, you can use just about any gauge you would like.
Date published: 2013-03-06
Will these binding posts accept banana plugs?
Yes these will accept banana plugs.
Date published: 2013-05-05
Would a banana plug be inserted straight down the center or from the side and then compressed by spring?
A banana plug will be inserted right from the rear of the connector just like any other binding post.
Date published: 2013-04-08
Will these work with existing binding posts
My old KLH-6 speakers have twist-down binding posts. I'd like to get a high-quality solution that will allow me to use banana plugs. So I'd like to remove the nuts from my speakers' binding posts and screw the end part of the assembly of this product to the KLH's binding posts. Will this work?
These are pretty large binding posts that require a hole that is 11/32" in diameter for mounting. There may be modifications required for this but I see no reason they will not work.
Date published: 2013-08-15
Are these binding posts long enough to clear 3/4" MDF? I didn't see any mention of the length. Thanks.
Yes these will fit through 3/4" material, the threads are 25mm (1") long.
Date published: 2014-04-01