Get your questions answered from other customers
who own this product or have experience with it.
If your question requires design or troubleshooting information,
please email firstname.lastname@example.org
for a prompt reply.
Dayton Audio BPA-38G HD Binding Post Pair Gold
Is this a replacement for a Klipsch AW-525?
I have a Klipsch AW-525 outdoor speaker with a broken binding post. Is this a suitable replacement?
Hi, Jerry. We don't carry any Klipsch parts, nor do we have a cross-reference by brand, model, or anything of the sort, unfortunately. However, if the mounting area for your Klipsch's binding posts is between 3/8" and 1" thick, with a 1/4" hole for the post(s), and you have at least 1-1/2" of clearance for the rear bolt, these should be suitable for the application.
Date published: 2011-06-01
Will .25" female disconnects work with the solder tabs?
Yes, 0.250" quick disconnects will fit those solder tabs.
Date published: 2011-06-06
proper way to install?
it has 2 nuts, a washer, and a solder tab on each one.. whats the order of install? Both nuts and the washer go on the inside right? In which order? And when should i attach the female disconnect, before or after tightening everything? Specifics would help (my first build, just trying to get it right)
These are to be installed washer, nut, solder tab, washer, nut.
Date published: 2013-04-24
What material are these post made of; Copper, Brass, Steel?
These are gold plated brass.
Date published: 2013-05-08
What size is the threaded part of the post? I want to use this with ring terminals. Will 1/4" ring terminals work?
I can answer half your question! I used crimp 1/4 ring connectors for mine and they worked very well. I found it helpful to put a little weak threadlock so the nut wouldn't back off, but the ring connector fits perfectly. I actually used Elmers glue rather than a "real" threadlocker and it has worked perfectly for the last 6 months. The threadlocker probably wouldn't be necessary on applications that won't shakes around as much as my TC Sounds sub box. The second part of your question I cannot answer without measuring, save for telling you it's slightly smaller than 1/4" to as to facilitate sliding into the 1/4" hole in front of the part that grips, but still fits the ring connector snugly. Maybe 7/32ths?
Date published: 2013-05-31
What are the dimensions of the hex base located just past the speaker wire hole in the picture? Edge dimension and width/thickness would help.
The hex is 11mm from flat edge to flat edge and 3mm thick.
Date published: 2013-06-17